99-7896 DASHKIT

Rockford Fosgate Punch amps

Rockford Fosgate continues to develop progressive sound technologies. Their aim — to produce a smaller amplifier, with all the power and clarity you expect from the Punch name.

Dynamic Thermal Management

The award-winning "Dynamic Thermal Management" 3-stage cooling system uses forced air to dissipate heat evenly across the amp and out through the heatsink. The internal components in these compact amps stay cooler, resulting in higher efficiency and lower distortion. You get more installation options, without sacrificing wattage or audio quality.

MEHSA cooling process

MEHSA is a Rockford Fosgate proprietary process that increases the heat transfer from the MOSFET devices to the heatsink. This allows the heat to escape more readily from the amplifier, so that the transistors stay cooler.

P500-2 Punch performance

The P500-2 2-channel amplifier dispenses 125 watts RMS per channel to your speaker system, or you can bridge it to send 500 watts to a sub. You can tailor the sound with variable-frequency high- and low-pass filters, and use the onboard EQ to add some high- and low-frequency punch to compensate for your car's acoustics. An optional wired remote control lets you tweak the sound from the front seat for quick adjustments while you're on the road.

Product highlights:

• 2-channel car amplifier
• 125 watts RMS x 2 at 4 ohms (250 watts RMS x 2 at 2 ohms)
• 500 watts RMS x 1 bridged output at 4 ohms (4-ohm stable in bridged mode)
• CEA-2006 compliant
• Dynamic Thermal Management cooling system
• variable high- and low-pass filters (50-500 Hz, 12 dB/octave)
• variable bass/treble boost (0-18 dB at 45 Hz, 0-12 dB at 12,000 Hz)
• optional wired remote bass/treble boost
• Class-AB amplifier design
• MOSFET power and output stages
• preamp inputs and outputs
• 4-gauge power and ground leads and a 100-amp fuse recommended — wiring and hardware not included with amplifier
• no on-board fuses — when installing multiple amps in a system, an additional 100-amp in-line fuse between the distribution block and the amplifier is recommended
• 13"W x 2-1/4"H x 8-1/2"D

https://pdf.crutchfieldonline.com/ImageBank/v20070606115700/Manuals/575/575P4002P.PDF